Centro (uo)
BCMaterials
Publicaciones (123) Publicaciones en las que ha participado algún/a investigador/a
2014
-
Effect of filler dispersion and dispersion method on the piezoelectric and magnetoelectric response of CoFe 2 O 4 /P(VDF-TrFE) nanocomposites
Applied Surface Science, Vol. 313, pp. 215-219
-
Ti 1-x Ag x electrodes deposited on polymer based sensors
Applied Surface Science, Vol. 317, pp. 490-495
-
A novel microstructured metal-supported solid oxide fuel cell
Journal of Power Sources, Vol. 272, pp. 233-238
-
All-inkjet-printed bottom-gate thin-film transistors using UV curable dielectric for well-defined source-drain electrodes
Journal of Electronic Materials, Vol. 43, Núm. 7, pp. 2631-2636
-
Aluminosilicate and aluminosilicate based polymer composites: Present status, applications and future trends
Progress in Surface Science, Vol. 89, Núm. 3-4, pp. 239-277
-
An investigation on the properties of SnO2 nanoparticles synthesized using two different methods
Journal of Materials Science: Materials in Electronics, Vol. 25, Núm. 1, pp. 303-310
-
Anion controlled structural and magnetic diversity in unusual mixed-bridged polynuclear NiII complexes with a versatile bis(2-methoxy phenol)diamine hexadentate ligand. An experimental and theoretical magneto-structural study
Dalton Transactions, Vol. 43, Núm. 36, pp. 13509-13524
-
Atomically well-defined Au25(SR)17/18 nanoclusters deposited on silica supports for the aerobic epoxidation of trans-stilbene
Catalysis Today, Vol. 235, pp. 72-78
-
Bio-based films prepared with by-products and wastes: Environmental assessment
Journal of Cleaner Production, Vol. 64, pp. 218-227
-
Carbon nanofiber type and content dependence of the physical properties of carbon nanofiber reinforced polypropylene composites
Polymer Engineering and Science, Vol. 54, Núm. 1, pp. 117-128
-
Characterization of polyaniline-based ammonia gas sensors prepared by means of spray coating and ink-jet printing
Sensor Letters, Vol. 12, Núm. 11, pp. 1620-1627
-
Comparative STM studies of mixed ligand monolayers on gold nanoparticles in air and in 1-phenyloctane
Chemical Communications, Vol. 50, Núm. 72, pp. 10456-10459
-
Comparative study of magnetic, microwave properties and giant magnetoimpedance of FeNi-based multilayers with different structure
Journal of Alloys and Compounds, Vol. 615, Núm. S1, pp. S296-S299
-
CuII-PDC-bpe frameworks (PDC = 2,5-pyridinedicarboxylate, bpe = 1,2-di(4-pyridyl)ethylene): Mapping of herringbone-type structures
CrystEngComm, Vol. 16, Núm. 37, pp. 8726-8735
-
Determination of heterogeneous electron transfer rate constants at interdigitated nanoband electrodes fabricated by an optical mix-and-match process
Sensors and Actuators, B: Chemical, Vol. 194, pp. 86-95
-
Determination of the structure factor of interparticle interactions in the ferrofluid by small-angle neutron scattering
Nuclear Physics and Atomic Energy, Vol. 15, Núm. 1, pp. 59-65
-
Development of high sensitive polyaniline based piezoresistive films by conventional and green chemistry approaches
Sensors and Actuators, A: Physical, Vol. 220, pp. 13-21
-
Direct formic acid microfluidic fuel cell design and performance evolution
Journal of Power Sources, Vol. 269, pp. 783-788
-
Distinction between SnO2 nanoparticles synthesized using co-Precipitation and solvothermal methods for the photovoltaic efficiency of dye-sensitized solar cells
Bulletin of Materials Science, Vol. 37, Núm. 4, pp. 903-909
-
Effect of carbon nanotube type and functionalization on the electrical, thermal, mechanical and electromechanical properties of carbon nanotube/styrene-butadiene-styrene composites for large strain sensor applications
Composites Part B: Engineering, Vol. 61, pp. 136-146