Ebaketa-erramintaren tenperaturak neurtzeko tornuko ebaketa eten bidezko fresaketaren simulazioa

  1. Octavio Pereira 1
  2. Alvaro Martínez 1
  3. Igor Ansoategui 1
  4. Iker Ganzarain 1
  5. Amaia Calleja 1
  1. 1 Ingeniaritza Mekanikako Saila. Euskal Herriko Unibertsitatea UPV/EHU
Revista:
Ekaia: Euskal Herriko Unibertsitateko zientzi eta teknologi aldizkaria

ISSN: 0214-9001

Any de publicació: 2017

Número: 32

Pàgines: 151-166

Tipus: Article

DOI: 10.1387/EKAIA.16354 DIALNET GOOGLE SCHOLAR lock_openAccés obert editor

Altres publicacions en: Ekaia: Euskal Herriko Unibertsitateko zientzi eta teknologi aldizkaria

Resum

In this work, milling simulation through interrupted turning process approx-imation is carried out. The main objective is to obtain cutting tool temperatures in the tool rake surface during the cutting process. In order to obtain these values, the milling process is approximated by the turning process. It is possible to assume this simplifica-tion when a longitudinally grooved workpiece is turned. This way, turning interrupted processes can be equate to milling processes due to milling interrupted cutting singularity. The tests measurements were carried out with a K-type thermocouple located at 0,5 mm from tool insert rake surface. The middle temperature value measured in the contact area will be estimated with a heat conduction theoretical model. Different trails with several cutting conditions are tested. Moreover, temperature difference between continuous and interrupted cutting for the same cutting time and cutting effective length is also studied.